Electric Water Heater Installation

water heater installed in garage

Electric Water Heater Installation a How to Guide. Eric the Plumber from Water Heating Experts WHE has a step by step guide of how we install electric hot water heaters in a garage. You can use this guide if you are skilled at do it your self projects. Also, if you want a professional to install your water heater this is the process that we take to install your water heater.

How to Install an Electric Water Heater In A Garage Step by Step.

  1. Locate the Electric Panel and Find The Breaker for the Water Heater.

    Find the Electric Panel and turn of the breaker for the water heater. Note: The marking may be wrong, so always check to make sure the power is off with a tester or multi-meter.electric panel in garage

  2. Remove The Electrical Connection from The Water Heater

    Take the cover off the electrical connections and remove the wiring. Secure the wire away from your work area and cover the bare ends of the wiring.

  3. Hook a hose to the drain at the bottom of the Water Heater.

    You can use a pump if you have one or let it drain the slow way. Note: you will need to open up the T&P valve or a hot side faucet in the home to break the airlock. Tip Leave the main valve on at full pressure for a few minutes to push out any sediment blocks. Then turn off the main water to the home and let the water heater drain with gravity or with your pump.draining old water heater with a pump and hose

  4. Cut the piping that attaches the Water Heater to the House Plumbing.

    Cut the copper piping or disconnect the flexible connections to the water heater. Do not cut too close to the wall because it will be hard to solder on a new ball valve for your new water heater.mini copper cutters cutting water heater pipes

  5. Remove the Water Heater

    Remove the old water heater. It will be much lighter now that it is drained. However, it still can require 2 people to load it into a truck. Clean the area around the water heater and prepare the piping that comes out of the wall for new plumbing valves and piping.

  6. Solder on New Ball Valve Shut-Offs

    Clean the piping that comes out of the wall with sand cloth and then use flux on both the valves, fittings and pipe. All connection areas should be cleaned with a wire brush or sand cloth and coated with a thin layer of flux.plumbing water heater shut off valves

  7. Attach copper risers to the new water heater

    Solder on some female adapters and one male adapter for the T&P valve. Then attach those pipes to the water heater’s threaded connections. Be sure to use plumber’s tape and some pipe dope. Also, do solder the pipes and let them cool down before attaching to the water heater.

  8. Make Your Final Plumbing Connections to the Pipes from the wall to the pipes on the water heater.

    Solder the pipes that are on the water heater to the pipes that extend from the wall. 

  9. Turn on the main water and leave a hot side faucet open

    Now that your final connections are made, you can turn on the water to the home and keep one hot side faucet open. Usually a laundry faucet or a large roman tub. Note: smaller faucets may get clogged because of the sediment left over.water to home shut off ball valve

  10. Wire the new water heater

    Make your final Wire Connections with new wire nuts to the wire that you took off from the old water heater. Note, make sure everything is in good condition and that the breaker is the correct size for the water heating elements.

  11. Turn the breaker back on and Your New Water Heater Should be Working

    Turn on the breaker, test that you have power to the unit and you now have a new water heater installed the correct way.
    water heater installed in garage