Where the Bradford White RE250T6 fits
The RE250T6 is the current tall 50-gallon model in this upright electric group. Its 20-inch jacket, 45 gallons of rated storage and 64-gallon first-hour rating distinguish it from the two short 50-gallon options.
This model is worth comparing when floor width is constrained and a taller installation is practical. The height measurement alone does not establish a fit: water piping, the electrical junction and future service access still need room. WHE also checks whether an existing pan and drain arrangement can be reused or need changes. A clear photograph of the entire installation is more helpful than a close-up of the label by itself.
Capacity, delivery and efficiency
Bradford White’s September 2026 U.S. specification lists 50 gallons nominal capacity, 45 gallons DOE rated storage, a 64-gallon first-hour rating and 0.92 UEF. Nominal capacity is the model’s size category; rated storage is the published stored volume. First-hour rating includes reheating during a standardized hour and should not be read as the amount held in the tank at once.
Use the first-hour figure to compare a busy period of use, then discuss the actual fixtures and timing. It is not a promise of a particular household size or an endless sequence of showers. UEF is a standardized efficiency measure, not a forecast of your bill. WHE does not assign a dollar saving without the existing heater, water use and electricity cost.
Dimensions and replacement access
- A — floor to top of heater: 59 inches.
- B — jacket diameter: 20 inches.
- C and E — floor to water and T&P connections: 60 1/4 inches.
- D — water-connection center spacing: 8 inches.
- G — water connections: 3/4-inch NPT.
- Approximate shipping weight: 130 pounds; this is not the filled operating weight.
Do not confuse RE250T6 with the archived RE350T6 listed farther down the manufacturer’s family page. The archived model has its own documents. A replacement for that older heater should be selected using the old nameplate and the current model’s verified dimensions and ratings, rather than carrying forward specifications from an older brochure.
RE250T6 is not one of the two supplied-blanket models marked in this specification table. Its jacket diameter should still not be treated as a complete installation footprint. Allow room for the pan, pipework and access to the element covers, drain and anode. Check the instructions delivered with the heater for the actual installation.
Compare the closest current models
The RE350S6 is lower at 47 3/16 inches with a 24-inch jacket and a 60-gallon first-hour rating. The RE250S6 is also 47 3/16 inches high, but its 22-inch bare jacket requires an external blanket. For greater stored volume, the RE255T6 lists 55 gallons of storage, a 75-gallon first-hour rating and a 23-inch jacket. It is 56 15/16 inches to the heater top.
Electrical configuration and recovery
This guide uses the sheet’s standard 240V, single-phase, non-simultaneous configuration with two 4,500W elements. Only one element operates at a time. The published recovery table gives 21 gallons per hour at a 90°F temperature rise for 4,500W operation. Recovery changes with the required rise and selected input; that figure is not the first-hour rating.
The RE250T6 row permits element wattages from 4,000W to 6,000W, subject to the voltage and wiring restrictions in the sheet. That ordering range is not an instruction to increase input on an existing circuit. Other factory configurations require separate verification. WHE checks the full nameplate, supply, circuit and wiring arrangement before installation; the base model number alone does not prove every electrical detail.
Installation and maintenance considerations
This is an indoor electric storage heater. WHE reviews the supporting surface, leak-management arrangement, shutoff access, relief discharge and thermal-expansion provisions where the supply is closed. Future service access matters even when the tank itself fits. If the present location is an attic, we can discuss whether a garage relocation is practical and include the necessary work in the estimate.
Sediment maintenance and anode inspection remain relevant. A sediment-control feature does not make the heater maintenance-free. Keep the model, serial number and installation record together, and report leaks, a change in hot-water delivery or repeated electrical trips for assessment. Have electrical diagnosis and internal service performed by a qualified professional following the supplied instructions.
Six-year model and warranty terms
The final 6 identifies the six-year tank model; the sheet lists 10-year versions separately. The current residential certificate provides six-year limited tank and component-parts coverage for qualifying single-family use, subject to its conditions. It shortens these terms to one year for other residential use of a six-year model and excludes nonresidential or commercial use. It also excludes replacement and repair costs, including removal, installation and associated charges, subject to applicable law. Retain the certificate supplied with the heater and confirm eligibility using the complete model and serial number.
Official sources and image note
Sources checked October 17, 2026: the current U.S. Upright Electric family, 1201-0926 specification sheet, 238-44422-00AB installation manual (August 2026) and 238-39699-00ZAN residential warranty (March 2025). The official family photograph is representative; proportions, labels and blanket arrangements vary. The exact model row and supplied equipment documents establish the configuration.
Plan your Bradford White replacement
Compare the Bradford White installation options, our electric water heater service and the full model catalog. Water Heating Experts is family owned and master plumber owned, serving Palm Beach Gardens, Jupiter and nearby Palm Beach County communities under Florida license CFC1426133. Call 561-602-9062 or request a free installation estimate with your model label and site photos. Availability, price and installation scope are confirmed for your project.
Bradford White RE250T6 FAQs
Is RE250T6 the same model as the archived RE350T6?
No. Bradford White lists RE250T6 in the current group and RE350T6 in an archive for models before May 2018. This guide uses the current RE250T6 row.
How much more delivery does RE250T6 list than the short 50-gallon models?
Its first-hour rating is 64 gallons, compared with 60 gallons for RE350S6 and RE250S6. All three list 45 gallons of DOE rated storage. The four-gallon first-hour difference is a test rating, not extra stored water.
Do both 4,500W elements operate together?
The standard configuration in the current sheet is 240V, single-phase and non-simultaneous. The controls energize one element at a time. Two elements do not make this a standard 9,000W simultaneous heater. Confirm the supplied nameplate.
Does the six-year warranty cover installation labor?
The current residential certificate provides six-year limited tank and parts terms for qualifying single-family use of this six-year model. It excludes replacement and repair costs such as removal, installation and associated charges, subject to applicable law. Other residential uses have shorter terms; the supplied certificate controls.
Can WHE assess RE250T6 for my home?
Yes. Send the existing model label, a wide installation photo and your hot-water concerns. WHE checks fit, demand, electrical supply and the scope of work for homes in Palm Beach Gardens, Jupiter and nearby Palm Beach County communities. Booking starts an estimate; equipment availability and scheduling are confirmed afterward.